Lagmaster Plus Purlin Plug

Product Code: LMP Purlin Plug

For 12 gauge ceiling wireFits Lagmaster PlusFits C / Z purlin clips

Hang & wrap 12GA ceiling wire to “C” & “Z” purlin/joist clips from the ground.

The LMP Purlin Plug allows you to install a purlin clip and tie-off ceiling wire in two easy steps, eliminating the need to purchase pre-tied ceiling wire. The LMP Purlin Plug makes it easy to install a purlin clip and then wrap ceiling wire to the clip (using the same tool), all from the safety of the ground. No ladders or scaffolding required.

Note: the LMP Purlin Plug is designed to be used in conjunction with a Lagmaster® Plus Pole Tool. If using a standard Lagmaster® Pole Tool, it will be necessary to purchase a LMP base to attach the LMP Purlin Plug to the pole.

Where to buy? Submittal Request

Specs

Documentation

Ready to Order?

Find a distributor near you, or request a submittal package for this product.

Where to buy? Submittal Request

Questions

Frequently Asked Questions

General

What is a Lagmaster Plus Plug?

A Lagmaster Plus Plug is an interchangeable adapter that connects tools, fasteners, or accessories to the Lagmaster Plus extension pole. You use it to adapt the pole for different installation tasks.

Are Lagmaster Plus Plugs sold as standalone parts?

Yes. These plugs are sold individually as replacement parts or add-ons, depending on your setup.

Compatibility

Which poles are Lagmaster Plus Plugs compatible with?

They are compatible with Lagmaster Plus extension poles. They are not intended for standard Lagmaster poles unless specified.

Can I use Lagmaster Plus Plugs with other Doc’s tools?

Some plugs are designed to work with specific Doc’s tools, such as Viper, Vertigo, or HOIT-AL systems. Always check the product description for confirmed compatibility.

Are these plugs interchangeable with each other?

Yes. You can swap plugs on a Lagmaster Plus pole depending on the task and tool you’re using.

Installation and Use

Do I need special tools to install a Lagmaster Plus Plug?

No. Plugs are designed for quick attachment and removal using standard hand tools or by tightening set screws where applicable.

Can Lagmaster Plus Plugs be used with power drills?

Some plugs are designed specifically for power-drill use, such as hex, square, or chuck adapters. Always match the plug type to your application.

Purchase and Availability

Where is Doc’s Industries based?

Doc’s Industries operates from Simi Valley, California, where products are designed, supported, and distributed through authorized partners.

How do I know which Lagmaster Plus Plug I need?

Choose based on the fastener size, tool type, and system you’re installing. If you’re unsure, the product code and description will guide you.

Are replacement parts available?

Yes. Replacement plugs, studs, screws, and adapters are available individually.

How can I purchase a lagmaster plus plug?

Use the “Where to Buy” tool on the Doc’s Industries website to locate an authorized distributor in your area or to request purchasing information.